Chapter 5 Quick Setup Wizards
ZyWALL USG Series User’s Guide
153
5.2.4 ISP and WAN and ISP Connection Settings
Use this screen to configure the ISP and WAN interface settings. This screen is read-only if you select
Ethernet and set the IP Address Assignment to Auto. If you set the IP Address Assignment to static and/or
select PPTP or PPPoE, enter the Internet access information exactly as your ISP gave it to you.
Note: Enter the Internet access information exactly as your ISP gave it to you.
Figure 122 WAN and ISP Connection Settings: (PPTP)
To Next Page
Loading...
