ZyXEL Communications USG40W - Policy Route Edit Screen

Chapter 11 Routing
ZyWALL USG Series User’s Guide
411
11.2.1 Policy Route Edit Screen
Click Configuration > Network > Routing to open the Policy Route screen. Then click the Add or Edit icon
in the IPv4 Configuration or IPv6 Configuration section. The Add Policy Route or Policy Route Edit screen
opens. Use this screen to configure or edit a policy route. Both IPv4 and IPv6 policy route have similar
settings except the Address Translation (SNAT) settings.
Figure 284 Configuration > Network > Routing > Policy Route > Add/Edit (IPv4 Configuration)