ZyXEL Communications USG40W - AP Management Screens; Mgnt. AP List

Chapter 9 Wireless
ZyWALL USG Series User’s Guide
274
Each field is described in the following table.
9.3 AP Management Screens
Use these screens to manage all of the APs connected to the Zyxel Device. Click Configuration >
Wireless > AP Management to access these screens.
Click on the icon to go to the OneSecurity website where there is guidance on configuration
walkthroughs and other information.
9.3.1 Mgnt. AP List
Figure 225 Configuration > Wireless > AP Management > Mgnt. AP List
Table 89 Configuration > Wireless > Controller
LABEL DESCRIPTION
Country Code Select the country code of APs that are connected to the Zyxel Device to be the same as where
the Zyxel Device is located/installed. The available channels vary depending on the country you
selected.
Registration
Type
Select Manual to add each AP to the Zyxel Device for management, or Always Accept to
automatically add APs to the Zyxel Device for management.
If you select Manual, then go to Monitor > Wireless > AP Information > AP List, select an AP to be
managed and then click Add to Mgnt AP List. That AP will then appear in Configuration > Wireless
> Controller > Mgnt. AP List.
Note: Select the Manual option for managing a specific set of APs. This is
recommended as the registration mechanism cannot automatically differentiate
between friendly and rogue APs.
APs must be connected to the Zyxel Device by a wired connection or network.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.