ZyXEL Communications USG40W - Zyxel One Network (ZON) System Screen

Chapter 44 System
ZyWALL USG Series User’s Guide
962
The following table describes the fields in the ZON Utility main screen.
44.17.3 Zyxel One Network (ZON) System Screen
Enable ZDP (ZON) and Smart Connect (Ethernet Neighbor) in the System > ZON screen.
See Monitor > System Status > Ethernet Neighbor for information on using Smart Connect (Link Layer
Discovery Protocol (LLDP)) for discovering and configuring LLDP-aware devices in the same broadcast
domain as the Zyxel Device that you’re logged into using the web configurator.
The following figure shows the System > ZON screen.
9 Configure NCC
Discovery
You must have Internet access to use this feature. Use this icon to enable or disable
Nebula Control Center (NCC) discovery on the selected device. If it’s enabled, the
selected device will try to connect to the NCC. Once the selected device is
connected to and has registered in the NCC, it’ll go into the cloud management
mode.
10 ZAC Use this icon to run the Zyxel AP Configurator of the selected AP.
11 Clear and Rescan Use this icon to clear the list and discover all devices on the connected network
again.
12 Save Configuration Use this icon to save configuration changes to permanent memory on a selected
device.
13 Settings Use this icon to select a network adaptor for the computer on which the ZON utility is
installed, and the utility language.
Table 390 ZON Utility Fields
LABEL DESCRIPTION
Type This field displays an icon of the kind of device discovered.
Model This field displays the model name of the discovered device.
Firmware Version This field displays the firmware version of the discovered device.
MAC Address This field displays the MAC address of the discovered device.
IP Address This field displays the IP address of an internal interface on the discovered device that
first received an ZDP discovery request from the ZON utility.
System Name This field displays the system name of the discovered device.
Location This field displays where the discovered device is.
Status This field displays whether changes to the discovered device have been done
successfully. As the Zyxel Device does not support IP Configuration, Renew IP address
and Flash Locator LED, this field displays “Update failed”, “Not support Renew IP
address” and “Not support Flash Locator LED” respectively.
NCC Discovery This field displays if the discovered device supports the Nebula Control Center (NCC)
discovery feature. If it’s enabled, the selected device will try to connect to the NCC.
Once the selected device is connected to and has registered in the NCC, it’ll go into
the cloud management mode.
Serial Number Enter the admin password of the discovered device to display its serial number.
Hardware Version This field displays the hardware version of the discovered device.
Table 389 ZON Utility Icons
ICON DESCRIPTION