Chapter 7 Monitor
ZyWALL USG Series User’s Guide
261
again to reverse the sort order. The Web Configurator saves the filter settings if you leave the View Log
screen and return to it later.
Figure 217 Monitor > Log > View Log
The following table describes the labels in this screen.
Table 83 Monitor > Log > View Log
LABEL DESCRIPTION
Show (Hide) Filter Click this button to show or hide criteria that allow you to filter logs that will be
displayed.
If the filter settings are hidden, the Category, Email Log Now, Refresh, and Clear Log
fields are available.
If the filter settings are shown, the Category, Priority, Source Address, Destination
Address, Source Interface, Destination Interface, Service, Keyword, criteria and Search
fields are available.
Category Select the type of log message(s) you want to view. You can also view All Logs at one
time, or you can view the Debug Log.
Priority This displays when you show the filter. Select the priority of log messages to display. The
log displays the log messages with this priority or higher. Choices are: any, emerg, alert,
crit, error, warn, notice, and info, from highest priority to lowest priority. This field is
grayed out if the Category is Debug Log.
Source Address This displays when you show the filter. Type the source IP address of the incoming
packet that generated the log message. Do not include the port in this filter.
To Next Page
Loading...
