Chapter 29 Amazon VPC
ZyWALL USG Series User’s Guide
604
• Your Customer Gateway ID: cgw-57b10356
Two tunnels are used to connect the Zyxel Device to the Amazon VPC. One is redundant and only takes
over if the first one fails.
There are 2 routing types for Amazon VPC.
• Static: A static route is created to send traffic to AWS. A connectivity check is used to check the
tunnel status. If a tunnel is down, the traffic switches to the redundant tunnel. You do not need to
configure BGP to route tunnel traffic between the Zyxel Device and AWS.
• Dynamic: Configure BGP to switch tunnel traffic dynamically between the Zyxel Device and AWS. If
you’re using dynamic routing, configure BGP on the Zyxel Device in Configuration > Network >
Routing > BGP using the AS, router ID and network information from the tunnel configurations you
just downloaded.
3 In the Zyxel Device, upload the VPC text file to the Zyxel Device in the Configuration > VPN > Amazon
VPC screen.
Figure 425 Configuration > VPN > Amazon VPC
4 The tunnel then establishes automatically.
To Next Page
Loading...
