Chapter 43 Object
ZyWALL USG Series User’s Guide
796
43.1.2.1 Zone Edit
The Zone Edit screen allows you to add or edit a zone. To access this screen, go to the Zone screen (see
Section 43.9.2 on page 855), and click the Add icon or an Edit icon.
Figure 548 Configuration > Object > Zone > Add
The following table describes the labels in this screen.
Member This field displays the names of the interfaces that belong to each zone.
Reference This field displays the number of times an Object Reference is used in a policy.
Table 291 Configuration > Object > Zone (continued)
LABEL DESCRIPTION
Table 292 Configuration > Object > Zone > Add/Edit
LABEL DESCRIPTION
Name For a system default zone, the name is read only.
For a user-configured zone, type the name used to refer to the zone. You may use 1-31
alphanumeric characters, underscores (
_), or dashes (-), but the first character cannot be
a number. This value is case-sensitive.
Member List Available lists the interfaces and VPN tunnels that do not belong to any zone. Select the
interfaces and VPN tunnels that you want to add to the zone you are editing, and click the
right arrow button to add them.
Member lists the interfaces and VPN tunnels that belong to the zone. Select any interfaces
that you want to remove from the zone, and click the left arrow button to remove them.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
