Chapter 43 Object
ZyWALL USG Series User’s Guide
802
Group Identifier This field is available for a ext-group-user type user account.
Specify the value of the AD or LDAP server’s Group Membership Attribute that identifies the
group to which this user belongs.
Associated AAA
Server Object
This field is available for a ext-group-user type user account. Select the AAA server to use to
authenticate this account’s users.
Description Enter the description of each user, if any. You can use up to 60 printable ASCII characters.
Default descriptions are provided.
Email Type one or more valid email addresses for this user so that email messages can be sent to
this user if required. A valid email address must contain the @ character. For example, this is
a valid email address: abc@example.com.
Mobile Number Type a valid mobile telephone number for this user so that SMS messages can be sent to this
user if required. A valid mobile telephone number can be up to 20 characters in length,
including the numbers 1~9 and the following characters in the square brackets [+*#()-].
Send Code This button is available when the user type is admin or limited-admin.
Click this and an authorization email or SMS message with a code of six digits will be sent to
the email addresses or mobile telephone number you put in.
Enter the verification code to verify your email addresses or mobile telephone number.
Figure 551 Verification Code for Email
Figure 552 Verification Code for Mobile Telephone Number
Authentication
Timeout Settings
If you want the system to use default settings, select Use Default Settings. If you want to set
authentication timeout to a value other than the default settings, select Use Manual Settings
then fill your preferred values in the fields that follow.
Lease Time If you select Use Default Settings in the Authentication Timeout Settings field, the default
lease time is shown.
If you select Use Manual Settings, you need to enter the number of minutes this user has to
renew the current session before the user is logged out. You can specify 1 to 1440 minutes.
You can enter 0 to make the number of minutes unlimited. Admin users renew the session
every time the main screen refreshes in the Web Configurator. Access users can renew the
session by clicking the Renew button on their screen. If you allow access users to renew time
automatically (see Section 43.2.4 on page 804), the users can select this check box on their
screen as well. In this case, the session is automatically renewed before the lease time
expires.
Table 295 Configuration > Object > User/Group > User > Add (continued)
LABEL DESCRIPTION
To Next Page
Loading...
