ZyXEL Communications USG40W - Page 950

Chapter 44 System
ZyWALL USG Series User’s Guide
950
Figure 676 Configuration > System > SNMP
The following table describes the labels in this screen.
Table 381 Configuration > System > SNMP
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that matches the IP
address(es) in the Service Control table to access the Zyxel Device using this service.
Server Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Trap
Community Type the trap community, which is the password sent with each trap to the SNMP manager. The
default is public and allows all requests.
Destination Type the IP address of the station to send your SNMP traps to.
SNMPv2c Select the SNMP version for the Zyxel Device. The SNMP version on the Zyxel Device must match
the version on the SNMP manager.
Get
Community
Enter the Get Community, which is the password for the incoming Get and GetNext requests
from the management station. The default is public and allows all requests.
Set
Community
Enter the Set community, which is the password for incoming Set requests from the
management station. The default is private and allows all requests.
SNMPv3 Select the SNMP version for the Zyxel Device. The SNMP version on the Zyxel Device must match
the version on the SNMP manager. SNMPv3 (RFCs 3413 to 3415) provides secure access by
authenticating and encrypting data packets over the network. The Zyxel Device uses your login
password as the SNMPv3 authentication and encryption passphrase.
Note: Your login password must consist of at least 8 printable characters for SNMPv3.
An error message will display if your login password has fewer characters.