Chapter 3 Connection Wizard
WAP3205 v3 User’s Guide
24
3.5 Connection Wizard - Universal Repeater Mode
In Universal Repeater mode, your WAP3205 v3 can act as an access point and wireless client at the
same time.
3.5.1 AP Select
The following screen will open. Use this screen to connect the WAP3205 v3 to a wireless network.
- IP Address This shows the LAN port’s IP Address.
- IP Subnet Mask This shows the LAN port’s IP Subnet Mask.
- DHCP Server This shows the LAN port’s DHCP server status.
WLAN Information
-MAC Address This shows the wireless adapter MAC Address of your device.
- Status This shows the current status of the Wireless LAN - Enabled or Disabled.
- Name (SSID) This shows a descriptive name used to identify the WAP3205 v3 in the
wireless LAN.
- Channel This shows the channel number which you select manually or Auto when
the WAP3205 v3 automatically scans and selects the Wireless Lan’s
channel.
- Operating Channel This shows the current channel number the WAP3205 v3 uses over the
wireless LAN.
- Security Mode This shows the data encryption method the WAP3205 v3 uses for the
wireless connection.
- 802.11 Mode This shows the IEEE 802.11 standard that the WAP3205 v3 supports.
Wireless clients must support the same standard in order to be able to
connect to the WAP3205 v3.
- WPS This displays Configured when the WPS (Wi-Fi Protected Setup) has been
set up.
This displays Unconfigured if the WPS has not been set up.
Run Wizard setup again Click here to run the Wizard setup one more time.
Go to advanced settings Click here to go to your WAP3205 v3’s advanced settings.
Table 5 Connection Wizard - Access Point Mode> Device Information
LABEL DESCRIPTION
To Next Page
Loading...
