ZyXEL Communications wap3205 V3 - Status Screen (Client Bridge Mode)

Chapter 4 Modes
WAP3205 v3 User’s Guide
41
6 A pop-up window appears providing information on this mode. Click OK in the pop-up message
window. Click Apply. Your WAP3205 v3 is now in Client Bridge mode.
Note: Wait while the WAP3205 v3 restarts, then log in to the Web Configurator again.
4.4.1 Status Screen (Client Bridge Mode)
Click on Status. The screen below shows the status screen in Client Bridge mode.
Figure 24 Status Screen (Client Bridge Mode)