Chapter 6 Wireless LAN
WAP3205 v3 User’s Guide
62
The following table describes the labels in this screen.
6.7 WPS Screen
Use this screen to enable/disable WPS, view or generate a new PIN number and check current WPS
status. To open this screen, click Network > Wireless LAN > WPS tab.
Figure 43 Network > Wireless LAN > WPS
The following table describes the labels in this screen.
Table 24 Network > Wireless LAN > Advanced
LABEL DESCRIPTION
Wireless Advanced Setup
Tx Power This field controls the transmission power of the WAP3205 v3. If there is a high density of APs in
an area, decrease the output power of the WAP3205 v3 to reduce interference with other
APs.
Enable Intra-BSS
Traffic
A Basic Service Set (BSS) exists when all communications between wireless clients or between
a wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is enabled, wireless
client A and B can access the wired network and communicate with each other. When Intra-
BSS is disabled, wireless client A and B can still access the wired network but cannot
communicate with each other.
Apply Click Apply to save your changes to the WAP3205 v3.
Reset Click Reset to reload the previous configuration for this screen.
Table 25 Network > Wireless LAN > WPS
LABEL DESCRIPTION
WPS Setup
Enable WPS Click the Enable WPS check box to enable the WPS feature. Click again to disable it.
PIN Number This displays a PIN number last time system generated. Click Generate to generate a new PIN
number.
WPS Status
To Next Page
Loading...
