Chapter 8 System
WAP3205 v3 User’s Guide
71
The following table describes the labels in this screen.
8.4 Time Setting Screen
To change your WAP3205 v3’s time and date, click Maintenance > System > Time Setting. The screen
appears as shown. Use this screen to configure the WAP3205 v3’s time based on your local time zone.
Figure 52 Maintenance > System > Time Setting
Table 31 Maintenance > System > General
LABEL DESCRIPTION
System Setup
System Name System Name is a unique name to identify the WAP3205 v3 in an Ethernet network. It is
recommended you enter your computer’s “Computer name” in this field (see the chapter
about wizard setup for how to find your computer’s name).
This name can be up to 30 alphanumeric characters long. Spaces are not allowed, but
dashes “-” and underscores "_" are accepted.
Domain Name Enter the Domain name (if you know it) here. This name is propagated to DHCP clients
connected to interfaces with the DHCP server enabled.
Administrator
Inactivity Timer
Type how many minutes a management session can be left idle before the session times out.
The default is 5 minutes. After it times out you have to log in with your password again. Very
long idle timeouts may have security risks. A value of "0" means a management session
never times out, no matter how long it has been left idle (not recommended).
Password Setup Change your WAP3205 v3’s password (recommended) using the fields as shown.
Old Password Type the default password or the existing password you use to access the system in this field.
New Password Type your new system password (up to 30 characters). Note that as you type a password,
the screen displays an asterisk (*) for each character you type.
Retype to Confirm Type the new password again in this field.
Apply Click Apply to save your changes back to the WAP3205 v3.
Reset Click Reset to begin configuring this screen afresh.
To Next Page
Loading...
