Chapter 6 Wireless LAN
WAP3205 v3 User’s Guide
61
Figure 41 Network > Wireless LAN > MAC Filter
The following table describes the labels in this menu.
6.6 Wireless LAN Advanced Screen
Use this screen to allow intra-BSS networking and set the RTS/CTS Threshold.
Click Network > Wireless LAN > Advanced. The screen appears as shown.
Figure 42 Network > Wireless LAN > Advanced
Table 23 Network > Wireless LAN > MAC Filter
LABEL DESCRIPTION
Active Click Active check box to enable MAC address filtering.
MAC Address
(White List)
This field shows the MAC addresses of the wireless station that are allowed or denied access to
the WAP3205 v3 in these address fields. Enter the MAC addresses in a valid MAC address format,
that is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Select Click the Select radio button to select a MAC filter entry.
Delete Click the Delete button to delete the selected MAC filter entry.
Delete All Click the Delete All button to remove all MAC filter entries.
MAC Address Enter the MAC addresses of the wireless station that are allowed or denied access to the
WAP3205 v3 in these address fields. Enter the MAC addresses in a valid MAC address format, that
is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Add Click Add to add a new MAC address to the MAC Filtering rule.
Apply Click Apply to save your changes back to the WAP3205 v3.
Reset Click Reset to reload the previous configuration for this screen.
To Next Page
Loading...
