ZyXEL Communications wap3205 V3 - Resetting the WAP3205 V3

Chapter 2 The Web Configurator
WAP3205 v3 User’s Guide
20
Figure 6 Selecting the setup mode
2.4 Resetting the WAP3205 v3
If you forget your password or IP address, or you cannot access the Web Configurator, you will need to
use the WPS/RESET button at the back of the WAP3205 v3 to reload the factory-default configuration file.
This means that you will lose all configurations that you had previously saved, the username will be reset
to admin and password will be reset to 1234. The IP address will be reset to “192.168.1.2”.
Make sure the power LED is on and press the WPS/RESET button for longer than 10 seconds to restart/
reboot and set the WAP3205 v3 back to its factory-default configurations.