Chapter 6 Wireless LAN
WAP3205 v3 User’s Guide
63
6.8 WPS Station Screen
Use this screen when you want to add a wireless station using WPS. To open this screen, click Network >
Wireless LAN > WPS Station tab.
Note: Note: After you click Push Button on this screen, you have to press a similar button in the
wireless station utility within 2 minutes. To add the second wireless station, you have to
press these buttons on both device and the wireless station again after the first 2
minutes.
Figure 44 Network > Wireless LAN > WPS Station
Status This displays Configured when the WAP3205 v3 has connected to a wireless network using WPS
or when Enable WPS is selected and wireless or wireless security settings have been changed.
The current wireless and wireless security settings also appear in the screen.
This displays Unconfigured if WPS is disabled and there are no wireless or wireless security
changes on the WAP3205 v3 or you click Release_Configuration to remove the configured
wireless and wireless security settings.
Release
Configuration
This button is only available when the WPS status displays Configured.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the WAP3205 v3.
802.11 Mode This shows the wireless LAN’s standard.
SSID This shows the descriptive name used to identify the WAP3205 v3 in the wireless LAN.
Security This shows the level of wireless security the WAP3205 v3 is using.
Apply Click Apply to save your changes back to the WAP3205 v3.
Refresh Click Refresh to get this screen information afresh.
Table 25 Network > Wireless LAN > WPS (continued)
LABEL DESCRIPTION
To Next Page
Loading...
