Chapter 3 Connection Wizard
WAP3205 v3 User’s Guide
25
Figure 11 Connection Wizard - Universal Repeater> AP Select
The following table describes the labels in this screen.
3.5.2 Wireless Setup
After you click Connect the following screen will open. Use this screen to enter the Wi-FI key if wireless
security is enabled on the selected AP.
Table 6 Connection Wizard - Universal Repeater> AP Select
LABEL DESCRIPTION
AP Select
First Click First button to go to the first page of the AP select table.
Previous Click Previous button to go to the previous page in the AP select table.
Next Click Next button to go to the next page in the AP select table.
Last Click Last to go to the last page of the AP select table.
Select Click to choose the wireless device your WAP3205 v3 will connect to.
SSID This displays Service Set IDentity of the wireless device. The SSID is a unique
name that identifies a wireless network. All devices in a wireless network
must use the same SSID.
MAC This displays the MAC address of the wireless device.
Channel This shows the channel number used by the wireless device.
Security Mode This shows the type of security configured on the wireless device. Open
means no security is configured and you can connect to it without a
password.
Strength This displays the strength of the wireless signal. The signal strength mainly
depends on the antenna output power and the distance between your
WAP3205 v3 and this device.
Refresh Click this button to search for available wireless devices within transmission
range and update this table.
Connect Click this button to associate to the selected wireless device.
To Next Page
Loading...
