Chapter 6 Wireless LAN
WAP3205 v3 User’s Guide
65
6.10 AP Select Screen
Use this screen to choose an access point that you want the WAP3205 v3 (in universal repeater mode)
to connect to. You should know the security settings of the target AP.
To open this screen, click Network > Wireless LAN > AP Select tab.
Figure 46 Network > Wireless LAN > AP Select
The following table describes the labels in this screen.
Except for the
following times
Select a begin time using the first set of hour and minute (min) drop down boxes and select an
end time using the second set of hour and minute (min) drop down boxes. If you have chosen
On earlier for the WLAN Status the Wireless LAN will turn off between the two times you enter in
these fields. If you have chosen Off earlier for the WLAN Status the Wireless LAN will turn on
between the two times you enter in these fields.
Note: Entering the same begin time and end time will mean the whole day.
Apply Click Apply to save your changes back to the WAP3205 v3.
Reset Click Reset to reload the previous configuration for this screen.
Table 27 Network > Wireless LAN > Scheduling (continued)
LABEL DESCRIPTION
Table 28 Network > Wireless LAN > AP Select
LABEL DESCRIPTION
AP Select
First Click First button to go to the first page of the AP select table.
Previous Click Previous button to go to the previous page in the AP select table.
Next Click Next button to go to the next page in the AP select table.
Last Click Last button to go to the last page of the AP select table.
To Next Page
Loading...
