Chapter 4 Modes
WAP3205 v3 User’s Guide
33
Figure 19 Client Bridge
4.2 Setting your WAP3205 v3 to AP Mode
1 Connect your computer to the LAN port of the WAP3205 v3.
2 The default LAN IP address of the WAP3205 v3 is 192.168.1.2. The WAP3205 v3 cannot assign your
computer an IP address, so you must give it a fixed IP address in the range between 192.168.1.3 and
192.168.1.254 (Section 2.2 on page 14).
3 After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and type the
IP address of the WAP3205 v3 as the web address in your web browser.
4 Log into the Web Configurator. See the Chapter 2 on page 14 for instructions on how to do this.
5 Go to Operation Mode > General and select Access Point.
6 A pop-up window appears providing information on this mode. Click OK in the pop-up message
window. Click Apply. Your WAP3205 v3 is now in AP Mode.
Note: Wait while the WAP3205 v3 restarts, then log in to the Web Configurator again.
To Next Page
Loading...
