ZyXEL Communications wap3205 V3 - Connection Wizard - Client Bridge Mode; AP Select

Chapter 3 Connection Wizard
WAP3205 v3 User’s Guide
29
3.6 Connection Wizard - Client Bridge Mode
The WAP3205 v3’s system operation mode is now Client Bridge, your WAP3205 v3 can act as a wireless
client to connect to an existing network via an access point.
3.6.1 AP Select
The AP Select screen will open. Use this screen to connect your WAP3205 v3 to an access point in the
area.
Figure 15 Connection Wizard - Client Bridge> AP Select
- WPS This displays Configured when the WPS has been set up.
This displays Unconfigured if the WPS has not been set up.
WLAN STA Information
- SSID This is the name of the selected AP that the WAP3205 v3 is associating with.
- Security Mode This shows the wireless security the WAP3205 v3 is using to connect to the
wireless device.
- Connection Status This shows whether the WAP3205 v3 is currently associated with the
selected AP.
- Connection Speed This shows the connection speed between the WAP3205 v3 and the
selected AP.
Run Wizard setup again Click here to run the Wizard setup one more time.
Go to Advanced setup Click here to go to your WAP3205 v3’s advanced settings.
Table 9 Connection Wizard - Universal Repeater> Device Information
LABEL DESCRIPTION