Chapter 6 Wireless LAN
WAP3205 v3 User’s Guide
54
6.2 What You Can Do
Wireless screens vary according to the device mode you are using.
See Chapter 4 on page 32 for more information on device modes.
• Use the General screen to enable the Wireless LAN, enter the SSID and select the wireless security
mode (Section 6.4 on page 56).
• Use the MAC Filter screen to allow or deny wireless stations based on their MAC addresses from
connecting to the WAP3205 v3 (Section 6.5 on page 60).
• Use the Advanced screen to allow intra-BSS networking and set the RTS/CTS Threshold (Section 6.6 on
page 61).
• Use the WPS screen to quickly set up a wireless network with strong security, without having to
configure security settings manually (Section 6.7 on page 62).
• Use the WPS Station screen to add a wireless station using WPS (Section 6.8 on page 63).
• Use the Scheduling screen to set the times your wireless LAN is turned on and off (Section 6.9 on page
64).
• Use the AP Select screen to choose an access point that you want the WAP3205 v3 (in universal
repeater mode) to connect to. You should know the security settings of the target AP (Section 6.10 on
page 65).
• Use the WLAN Information screen to view the SSID and security of the selected AP wireless network
(Section 6.11 on page 66).
6.3 What You Should Know
Every wireless network must follow these basic guidelines.
• Every wireless client in the same wireless network must use the same SSID.
The SSID is the name of the wireless network. It stands for Service Set IDentity.
Wireless Screen Access Point Universal Repeater Client Bridge
General
MAC Filter
Advanced
WPS
WPS Station
Scheduling
AP Select
WLAN Information
To Next Page
Loading...
