Chapter 4 Modes
WAP3205 v3 User’s Guide
35
4.2.2 AP Navigation Panel
Use the menu in the navigation panel to configure WAP3205 v3 features in AP Mode.
The following screen and table show the features you can configure in AP Mode.
Figure 21 Menu: AP Mode
- WPS This displays Configured when the WPS (Wi-Fi Protected Setup) has been set up.
This displays Unconfigured if the WPS has not been set up.
System Status
Operation Mode This field shows the device operating mode: Access Point, Universal Repeater or Client
Bridge.
System Up Time This is the total time the WAP3205 v3 has been on.
Current Date/Time This field displays your WAP3205 v3’s present date and time.
Interface Status
Interface This displays the WAP3205 v3 port types.
Status For the LAN ports, this field displays Down (line is down) or Up (line is up or connected).
For the WLAN, it displays Up when the WLAN is enabled or Down when the WLAN is
disabled.
Rate For the LAN ports, this displays the port speed or N/A when the line is disconnected.
For the WLAN, it displays the maximum transmission rate when the WLAN is enabled and
N/A when the WLAN is disabled.
Summary
Client Table Use this screen to view current client information. Click “Details...” to see the screen.
Packet Statistics Use this screen to view port status and packet specific statistics. Click “Details...” to see
the screen.
Message Use this screen to view the status of the WAP3205 v3.
Table 12 Status Screen (AP Mode) (continued)
LABEL DESCRIPTION
To Next Page
Loading...
