Chapter 13 Troubleshooting
WAP3205 v3 User’s Guide
86
The Internet connection is slow or intermittent.
1 There might be a lot of traffic on the network. Look at the LEDs, and check Section 1.3 on page 11. If the
WAP3205 v3 is sending or receiving a lot of information, try closing some programs that use the Internet,
especially peer-to-peer applications.
2 Check the signal strength. If the signal strength is low, try moving the WAP3205 v3 closer to the AP if
possible, and look around to see if there are any devices that might be interfering with the wireless
network (for example, microwaves, other wireless networks, and so on).
3 Reboot the WAP3205 v3.
4 If the problem continues, contact the network administrator or vendor, or try one of the advanced
suggestions.
13.4 Resetting the WAP3205 v3 to Its Factory Defaults
If you reset the WAP3205 v3, you lose all of the changes you have made. The WAP3205 v3 re-loads its
default settings, and the username/password resets to admin/1234. You have to make all of your
changes again.
You will lose all of your changes when you push the WPS/RESET button.
To reset the WAP3205 v3,
1 Make sure the power LED is on.
2 Press the WPS/RESET button for longer than 10 second to reboot and restore factory-default
configurations on the WAP3205 v3.
If the WAP3205 v3 restarts automatically, wait for the WAP3205 v3 to finish restarting, and log in to the
Web Configurator. The username is admin and password is 1234.
If the WAP3205 v3 does not restart automatically, disconnect and reconnect the WAP3205 v3’s power.
Then, follow the directions above again.
13.5 Wireless Problems
I cannot access the WAP3205 v3 or ping any computer from the WLAN.
To Next Page
Loading...
