WAP3205 v3 User’s Guide
83
CHAPTER 13
Troubleshooting
This chapter offers some suggestions to solve problems you might encounter. The potential problems are
divided into the following categories.
• Power, Hardware Connections, and LEDs
• WAP3205 v3 Access and Login
• Internet Access
• Resetting the WAP3205 v3 to Its Factory Defaults
• Wireless Problems
13.1 Power, Hardware Connections, and LEDs
The WAP3205 v3 does not turn on. None of the LEDs turn on.
1 Make sure you are using the power adaptor or cord included with the WAP3205 v3.
2 Make sure the power adaptor or cord is connected to the WAP3205 v3 and plugged in to an
appropriate power source. Make sure the power source is turned on.
3 Disconnect and re-connect the power adaptor or cord to the WAP3205 v3.
4 If the problem continues, contact the vendor.
One of the LEDs does not behave as expected.
1 Make sure you understand the normal behavior of the LED. See Section 1.3 on page 11.
2 Check the hardware connections. See the Quick Start Guide.
3 Inspect your cables for damage. Contact the vendor to replace any damaged cables.
4 Disconnect and re-connect the power adaptor to the WAP3205 v3.
5 If the problem continues, contact the vendor.
To Next Page
Loading...
