Chapter 12 Operation Mode
WAP3205 v3 User’s Guide
82
If you select a mode (Access Point, Universal Repeater or Client Bridge) the following pop-up message
window appears.
Figure 66 Maintenance > Operation Mode > General
• All Ethernet ports have the same IP address.
• All ports on the rear panel of the device are LAN ports. There is no WAN port.
• The DHCP server on your device is disabled. In this mode there must be a device with a DHCP server
on your network such as a router which can allocate IP addresses or else you need to manually assign
IP addresses to devices on your network.
• The LAN IP address of the WAP3205 v3 is set to 192.168.1.2.
Apply Click Apply to save your settings.
Reset Click Reset to return to the previous screen settings.
Table 36 Maintenance > Operation Mode > General (continued)
LABEL DESCRIPTION
To Next Page
Loading...
