Chapter 4 Modes
WAP3205 v3 User’s Guide
43
Figure 25 Menu: Client Bridge Mode
The following table describes the sub-menus.
Table 17 Menu: Client Bridge Mode
LINK TAB FUNCTION
Status This screen shows the WAP3205 v3’s general device, system and interface
status information. Use this screen to access the wizard, and summary
statistics tables.
Network
AP Select AP Select Use this screen to choose an access point that you want the WAP3205 v3 to
connect to. You should know the security settings of the target AP.
WLAN
Information
Use this screen to view the SSID and security mode of the AP to which the
WAP3205 v3 is connecting.
Advanced This screen allows you to configure advanced wireless settings.
LAN IP Use this screen to configure LAN IP address and subnet mask.
Maintenance
System General Use this screen to view and change administrative settings such as system
and domain names, password and inactivity timer.
Time Setting Use this screen to change your WAP3205 v3’s time and date.
Logs View Log Use this screen to view the logs for the categories that you selected.
Tools Firmware Use this screen to upload firmware to your WAP3205 v3.
Configuration Use this screen to backup and restore the configuration or reset the factory
defaults to your WAP3205 v3.
Restart This screen allows you to reboot the WAP3205 v3 without turning the power
off.
Language This screen allows you to select the language you prefer.
Operation
Mode
General This screen allows you to select the device operating mode: Access Point,
Universal Repeater or Client Bridge.
To Next Page
Loading...
