Chapter 6 Wireless LAN
WAP3205 v3 User’s Guide
57
Figure 37 Network > WLAN > General (Universal Repeater Mode)
The following table describes the general wireless LAN labels in this screen.
Table 19 Network > Wireless LAN > General
LABEL DESCRIPTION
WLAN STA
Information
This section is available only when the WAP3205 v3 is in universal repeater mode. This shows the
wireless and security settings of the selected AP wireless network.
SSID This displays the Service Set IDentity of the wireless device to which you are connecting.
Security Mode This displays the type of security configured on the wireless device to which you are connecting.
Operating
Channel
This displays the channel used by the wireless device to which you are connecting.
WLAN AP
Information /
Wireless Setup
Use this section to configure the wireless settings between the WAP3205 v3 and its wireless clients.
Enable Wireless
LAN
Click the check box to activate wireless LAN.
802.11 Mode Click the drop-down list to choose the 802.11 mode you want to operate.
Name(SSID) (Service Set IDentity) The SSID identifies the Service Set with which a wireless station is associated.
Wireless stations associating to the access point (AP) must have the same SSID. Enter a
descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless LAN.
Enable SSID
Broadcast
Select the Enable SSID Broadcast check box to enable the SSID in the outgoing beacon frame so
a station cannot obtain the SSID through scanning using a site survey tool.
Channel
Selection
Set the operating frequency/channel depending on your particular region.
Select a channel from the drop-down list box. The options vary depending on the frequency
band and the country you are in.
Refer to the Connection Wizard chapter for more information on channels. This option is only
available if Auto Channel Selection is disabled.
Operating
Channel
This displays the channel the WAP3205 v3 is currently using.
To Next Page
Loading...
