2N IP Verso - Page 175

Installation manual 2N® IP Verso
175 / 241
•
•
•
•
•
•
Dynamic IP Address Setting
Follow the instructions below to switch on theDynamic IP addressmode (DCHP ON):
Press and hold the RESET button.
Wait until the red and green LEDs go on simultaneously on the device and the acoustic
signal can be heard (approx. 15–35 s).
Wait until the red LED goes off andthe acoustic signal can be heard (approx. for
another 3 s).
Wait until the green LED goes off and the red LED goes on again andthe acoustic signal
can be heard (approx. for another 3 s).
Release the RESET button.
Factory Reset
Follow the instructions below toreset the factory default values:
Press and hold the RESET button.