2N IP Verso - Page 176

Installation manual 2N® IP Verso
176 / 241
•
•
•
•
•
Wait until the red and green LEDs go on simultaneously and the acoustic signal can be
heard (approx. 15–35 s).
Wait until the red LED goes off andthe acoustic signal can be heard (approx. for
another 3 s).
Wait until the green LED goes off and the red LED goes on again andthe acoustic signal
can be heard (approx. for another 3 s).
Wait until the red LED goes off andthe acoustic signal can be heard (approx. for
another 3 s).
Release the RESET button.
Device Restart
Press the RESET button shortly (< 1 s) to restart the system without changing configuration.
•
Caution
In case of resetting the factory default settings on a device with a version of
firmware 2.18 or higher it is necessary to reprogram the
2N
®
Security Relay using the instructions from section 2.4.
