Installation manual 2N® IP Verso
1.
2.
3.
4.
5.
•
•
Nametag inserting/replacing:
Remove the frame.
Lift up the button door. The 5-button module buttons have just one door.
Remove the used nametag and insert a new one.
Close the button door.
Replace the frame.
Frame Replacement
Check the frame sealing before replacing the frame.
Version A
Screw the flush mounting frame in the upper and bottom parts.
Version B
Hang the surface mounting frame on the hook in the upper part and then screw it tight in
the bottom part.
Most Frequent Mounting Errors
At first, mount the metal bolts, level the bases on an even surface and tighten the screws.
•
•
Caution
The area where nametags are placed is called a wet zone. After heavy rain, water
can penetrate to the nametag. Water in this area does not affect the intercom
functionality in any way and evaporates soon.
Always use waterproof foil (enclosed or other) for the nametags. Never use paper
or ink jet printing to avoid damage due to water leakage!
•
•
•
Caution
Improper mounting may deteriorate the intercom waterproofness and water may
damage the electronic part.
Make sure that all holes are filled with some waterproof material– the top part,
around the cables and the screws.
Use silicone or some other sealant to seal the box against the wall if uneven to
avoid water leakage and wall damping..
Caution
To Next Page
Loading...
