2N IP Verso - Page 214

Installation manual 2N® IP Verso
214 / 241
•
•
Repeated pressing of one and the same quick dial button during call setup may initiate call
hangup or call termination plus dialling the next phone number of the called subscriber, or may
be assigned no function; refer to theIntercom Configuration / Hardware / Keypadsubsection of
Configuration Manual.
You can also press the button anytime to hang up if enabled so in theButton Function
During Call parameter; refer to theIntercom Configuration / Hardware / Keypadsubsection of
Configuration Manual.
Calling to Phone Book Position
The2N
®
IP VersoPhone Book can contain up to 10 000 programmable positions. The quick dial
buttons can only be used for positions 1 through 146, depending on the number of actually
installed buttons. You can dial the other positions using the numeric keypad if theDial by
Numeric Keypadfunction is enabled; refer to theIntercom Configuration / Hardware /
Keypadsubsection of Configuration Manual.
Procedure:
Enter the position number using the numeric keypad (05, 15, 200, e.g. – two digits at least
and four digits at most) and press the button for confirmation.
You can also press the button anytime to hang up if enabled so in theButton Function
During Call parameter; refer to theIntercom Configuration / Hardware /
Keypadsubsection of Configuration Manual.