2N IP Verso - Page 215

Installation manual 2N® IP Verso
215 / 241
1.
2.
3.
4.
•
•
Calling to User-Defined Phone Number
If theTelephone function enabled(refer to theIntercom Configuration / Hardware /
Keypadsubsection of Configuration Manual) parameter is selected, you can dial a user-defined
phone number using the2N
®
IP Versonumeric keypad.
Procedure:
Press .
You will hear a continuous tone from the speaker.
Enter the phone number via the numeric keypad and press again to confirm your
dialling.
You can also press the button anytime to hang up if enabled so in theButton Function
During Call parameter; refer to theIntercom Configuration / Hardware /
Keypadsubsection of Configuration Manual.
Incoming Call Answering/Rejecting
If the automatic incoming call answering function is disabled (refer totheIntercom
Configuration / Services / Phone / Calls subsection of Configuration Manual), the incoming call
to2N
®
IP Versois signalled with loud ringing. Press to answer the call and to reject the
call.
Door Opening (Switch Activation) by Code
2N
®
IP Versois equipped with a door unlocking switch. Enter the valid code (refer to
theIntercom Configuration / Hardware / Switches subsection of Configuration Manual) using the
numeric keypad to activate this switch.
Procedure:
Enter the switch activating numerical code using the numeric keypad and press for
confirmation.
A valid code is notified visually and by a continuous switch activation tone or a predefined
unlocking user sound. An invalid codeor interruption longer than as defined in Timeout
for Entering Numbersis signalled by the sound or a user sound.