3Com 5500-EI PWR - Configuring IGMP Proxy

11
Configuring simulated joining in interface view
Follow these steps to configure simulated joining in interface view:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter interface view
interface interface-type interface-number
—
VLAN interface
view
igmp host-join
group-address port
interface-list
Configure one or more ports in
the VLAN as simulated
member host(s) of the specified
multicast group
LoopBack
interface view
igmp host-join
group-address
Required
Disabled by
default
Configuring simulated joining in Ethernet port view
Follow these steps to configure simulated joining in Ethernet port view:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the port in the specified VLAN
as a simulated member host of the
specified multicast group
igmp host-join group-address
vlan vlan-id
Required
Disabled by default
z Before configuring simulated joining, you must enable IGMP in interface view first.
z If you configure simulated joining in Ethernet port view, the Ethernet port must belong to the
specified VLAN; otherwise the configuration does not take effect.
Configuring IGMP Proxy
Follow these steps to configure IGMP proxy:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter VLAN interface view
interface Vlan-interface
interface-number
—
Configure IGMP proxy
igmp proxy Vlan-interface
interface-number
Required
Disabled by default