1-8
Set the SSH authentication
timeout time
ssh server timeout seconds
Optional
By default, the SSH
authentication timeout time is 60
seconds.
Set the number of SSH
authentication retry attempts
ssh server
authentication-retries times
Optional
By default, the number of SSH
authentication retry attempts is 3.
Set the RSA server key update
interval
ssh server rekey-interval
hours
Optional
By default, the system does not
update the RSA server keys.
Configure a login header
header shell text
Optional
By default, no login header is
configured.
Specify a source IP address for
the SSH server
ssh-server source-ip
ip-address
Optional
By default, no source IP address
is configured.
Specify a source interface for
the SSH server
ssh-server source-interface
interface-type
interface-number
Optional
By default, no source interface is
configured.
z You can configure a login header only when the service type is stelnet. For configuration of
service types, refer to
Specifying a Service Type for an SSH User.
z For details of the header command, refer to the corresponding section in Login Command.
Configuring the SSH Server to Be Compatible with SSH1 Clients
Follow these steps to configure the SSH server to be compatible with SSH1 clients:
To do... Use the command... Remarks
Enter system view
system-view
—
Configure the SSH server to be
compatible with SSH1 clients
ssh server
compatible-ssh1x enable
Optional
By default, the SSH server is
compatible with SSH1 clients.
Configuring Key Pairs
The SSH server’s key pairs are for generating session keys and for SSH clients to authenticate the
server. The SSH client's key pairs are for the SSH server to authenticate the SSH clients in publickey
authentication mode. Both RSA and DSA key pairs are supported.
To Next Page
Loading...
