2-24
Create a HWTACACS scheme
and enter its view
hwtacacs scheme
hwtacacs-scheme-name
Required
By default, no HWTACACS
scheme exists.
Set a shared key for
HWTACACS authentication,
authorization or accounting
messages
key { accounting |
authorization |
authentication } string
Required
By default, no such key is set.
Configuring the Attributes of Data to be Sent to TACACS Servers
Follow these steps to configure the attributes for data to be sent to TACACS servers:
To do… Use the command… Remarks
Enter system view
system-view
—
Create a HWTACACS scheme
and enter its view
hwtacacs scheme
hwtacacs-scheme-name
Required
By default, no HWTACACS
scheme exists.
Set the format of the
usernames to be sent to
TACACS server
user-name-format
{ with-domain |
without-domain }
Optional
By default, the usernames sent
from the switch to TACACS
server carry ISP domain
names.
data-flow-format data { byte |
giga-byte | kilo-byte |
mega-byte }
Set the units of data flows to
TACACS servers
data-flow-format packet
{ giga-packet | kilo-packet |
mega-packet | one-packet }
Optional
By default, in a TACACS
scheme, the data unit and
packet unit for outgoing
HWTACACS flows are byte
and one-packet respectively.
HWTACACS scheme view
nas-ip ip-address
Set the source IP address of
outgoing HWTACACS
messages
System view
hwtacacs nas-ip ip-address
Optional
By default, no source IP
address is set; the IP address
of the corresponding outbound
interface is used as the source
IP address.
Generally, the access users are named in the userid@isp-name or userid.isp-name format. Where,
isp-name after the “@” or “.” character represents the ISP domain name. If the TACACS server does not
accept the usernames that carry ISP domain names, it is necessary to remove domain names from
usernames before they are sent to TACACS server.
Configuring the Timers Regarding TACACS Servers
Follow these steps to configure the timers regarding TACACS servers:
To Next Page
Loading...
