1-11
View
Available
operation
Prompt example Enter method Quit method
MSDP view
Configure MSDP
parameters
[Sysname-msdp]
Execute the msdp
command in
system view.
PoE profile
view
Configure PoE
profile parameters
[Sysname-poe-pro
file-a123]
Execute the
poe-profile
command in
system view.
Smart link
group view
Configure smart
link group
parameters
[Sysname-smlk-gr
oup1]
Execute the
smart-link group
command in
system view.
Monitor link
group view
Configure monitor
link group
parameters
[Sysname-mtlk-gro
up1]
Execute the
monitor-link
group command in
system view.
Detected
group view
Configure detected
group parameters
[Sysname-detect-g
roup-1]
Execute the
detect-group
command in
system view.
QinQ view
Configure QinQ
parameters
[Sysname-Etherne
t1/0/1-vid-20]
Execute the
vlan-vpn vid
command in
Ethernet port view.
The vlan-vpn
enable command
should be first
executed.
Execute the
quit command
to return to
Ethernet port
view.
Execute the
return
command to
return to user
view.
The shortcut key <Ctrl+Z> is equivalent to the return command.
CLI Features
Online Help
When configuring the switch, you can use the online help to get related help information. The CLI
provides two types of online help: complete and partial.
Complete online help
1) Enter a question mark (?) in any view on your terminal to display all the commands available in the
view and their brief descriptions. The following takes user view as an example.
<Sysname> ?
User view commands:
backup Backup current configuration
To Next Page
Loading...
