3Com 5500-EI PWR - Displaying and Maintaining Route Capacity Limitation Configuration

6-3
To do... Use the command... Remarks
Enable automatic protocol
recovery
memory auto-establish
enable
Optional
Enabled by default
Follow these steps to disable automatic protocol recovery:
To do... Use the command... Remarks
Enter system view
system-view
—
Disable automatic protocol
recovery
memory auto-establish
disable
Optional
Enabled by default.
If automatic protocol recovery is disabled, the OSPF connection will not recover even when the free
memory exceeds the safety value. Therefore, take cautions when disabling the function.
Displaying and Maintaining Route Capacity Limitation
Configuration
Follow these steps to display route capacity configuration:
To do... Use the command... Remarks
Display memory occupancy of a
switch
display memory [ unit
unit-id ]
Display the route capacity related
memory setting and state
information
display memory limit
Available in any view