3Com 5500-EI PWR - Displaying Poe Profile Configuration; Poe Profile Application Example; Poe Profile Configuration Example

2-3
Displaying PoE Profile Configuration
To do… Use the command… Remarks
Display the detailed information
about the PoE profiles created
on the switch
display poe-profile { all-profile |
interface interface-type interface-number |
name profile-name }
Available in any
view
PoE Profile Configuration Example
PoE Profile Application Example
Network requirements
Switch A is a Switch 5500-EI supporting PoE.
Ethernet 1/0/1 through Ethernet 1/0/10 of Switch A are used by users of group A, who have the following
requirements:
z The PoE function can be enabled on all ports in use.
z Signal mode is used to supply power.
z The PoE priority for Ethernet 1/0/1 through Ethernet 1/0/5 is Critical, whereas the PoE priority for
Ethernet 1/0/6 through Ethernet 1/0/10 is High.
z The maximum power for Ethernet 1/0/1 through Ethernet 1/0/5 ports is 3000 mW, whereas the
maximum power for Ethernet 1/0/6 through Ethernet 1/0/10 is 15400 mW.
Based on the above requirements, two PoE profiles are made for users of group A.
z Apply PoE profile 1 for Ethernet 1/0/1 through Ethernet 1/0/5;
z Apply PoE profile 2 for Ethernet 1/0/6 through Ethernet 1/0/10.