1-17
In system
view
dot1x supp-proxy-check
{ logoff | trap } [ interface
interface-list ]
interface interface-type
interface-number
dot1x supp-proxy-check
{ logoff | trap }
Enable proxy
checking for a
port/specified
ports
In port view
quit
Required
By default, the 802.1x proxy
checking is disabled on a port.
Note:
z The proxy checking function needs the cooperation of H3C's 802.1x client (iNode) program.
z The proxy checking function depends on the online user handshaking function. To enable the
proxy detecting function, you need to enable the online user handshaking function first.
z The configuration listed in the above table takes effect only when it is performed on CAMS as well
as on the switch. In addition, the client version checking function needs to be enabled on the switch
too (by using the dot1x version-check command).
Configuring Client Version Checking
Follow these steps to configure client version checking:
To do... Use the command... Remarks
Enter system view
system-view
—
In system
view
dot1x version-check [ interface
interface-list ]
interface interface-type
interface-number
dot1x version-check
Enable
802.1x client
version
checking
In port
view
quit
Required
By default, 802.1x client version
checking is disabled on a port.
Set the maximum number
of retires to send version
checking request packets
dot1x retry-version-max
max-retry-version-value
Optional
By default, the maximum number
of retires to send version checking
request packets is 3.
Set the client version
checking period timer
dot1x timer ver-period
ver-period-value
Optional
By default, the timer is set to 30
seconds.
Note:
As for the dot1x version-user command, if you execute it in system view without specifying the
interface-list argument, the command applies to all ports. You can also execute this command in port
view. In this case, this command applies to the current port only and the interface-list argument is not
needed.
To Next Page
Loading...
