2-3
To do… Use the command… Remarks
Configure packet
filtering
packet-filter { inbound |
outbound } acl-rule
Optional
Refer to the ACL module of
this manual for information
about packet filtering.
Configure priority
marking
traffic-priority { inbound |
outbound } acl-rule { { dscp
dscp-value | ip-precedence
{ pre-value | from-cos } } | cos
{ pre-value | from-ipprec } |
local-precedence pre-value }*
Optional
Applying a QoS Profile
You can configure to apply a QoS profile dynamically or simply apply a QoS profile
manually.
Configuration prerequisites
z To configure to apply a QoS profile dynamically, make sure 802.1x is enabled both
globally and on the port, and the authentication mode is determined. For information
about 802.1x, refer to the 802.1x and System Guard module of this manual.
z To apply a QoS profile manually, make sure the port to which the QoS profile is to be
applied is determined.
z The QoS profile to be applied is determined.
Configuration procedure
Follow these steps to configure to apply a QoS profile dynamically:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface
interface-type
interface-number
—
To Next Page
Loading...
