Move the model into the preferred position on the print pad.4.
NOTE: You can specify the distance you want to move the model by inputing values in
the Move X or Move Y fields and then selecting Move X or Move Y.
NOTE: Auto Place allows the software to place the model in an optimum position.
NOTE: Selecting Move Model allows you to click and drag the model around the print
pad.
If necessary, scale and rotate the model by entering the values and selecting the corresponding buttons.5.
Select the color you wish to use and then select the part.6.
NOTE: If working with an assembly, select a color and then the part you wish to
change.
NOTE: If you need to replace a cartridge for a different color or material type, refer to
the section Replacing A Material Cartridge. Then, verify the material type and color by
reviewing the Printer Configuration settings under the Settings tab in the software.
Select the color again to deselect it.7.
Select Build.8.
Enter the appropriate build settings and select Build.9.
NOTE: Refer to the section called Build Settings under the View Tab for more
information.
Browse to the location where the file will be saved and enter a file name. Select CubePro Build Files as Save As Type. Select Save.10.
To Next Page
Loading...
Need help?
General
