UNPACKING AND INITIAL SETUP
CAUTION: Due to the size and weight of the printer, this procedure may require more
than one person. Ensure there are enough people to safely and comfortably move the
printer to its final location.
NOTE: Ensure that you save all foam and packing material for the future repacking of
your CubePro. Transporting the printer without original packing materials may
damage the printer
Carefully cut the straps if applicable and then pull the tabs on all four release clips.1.
NOTE: There is one release clip on each side of the box.
Pull the handles (A) and remove the release clips from the outer box.2.
Lift the box away from the printer.3.
Remove the accessories tray (A).4.
To Next Page
Loading...
Need help?
General
