PRINT JET TEMPERATURE CALIBRATION
New print jet extruders have temperature calibration values printed on a label attached to the
extruder. After replacing an extruder, the values for the new nozzle should be entered into the printer for
optimum printing results.
Procedure
Select SETUP.1.
Navigate to CALIBRATION and select it.2.
Select JET TEMP CALIBRATION.3.
Select the nozzle assembly that was replaced. Select the T1 value and use the arrows to enter the appropriate T1 value found on the label adhered to the4.
new extruder.
Select the T2 value and use the arrows to enter the appropriate value found on the label adhered to the new extruder.5.
To Next Page
Loading...
