CLEANING EXTERIOR SURFACES
Do not remove any outer panels when cleaning the printer. Panels must only be removed by qualified 3D Systems Technical Support Representatives.
Remove dust from outer surfaces of printer by wiping with a clean, dry, lint-free cloth.
Remove dirt and grease from printer outer surface by spraying all-purpose cleaner on a clean cloth and gently wiping it down.
CAUTION: Use only non-abrasive, alcohol-free cleaners to clean surfaces. Do not use all-purpose cleaners containing petroleum-based
polishing agents such as liquid wax.
NOTE: Before cleaning, the 3D printer system must be idle to avoid aborting a build.
To Next Page
Loading...
