3D Systems projet mjp 2500

To Next Page

To Previous Page

Give this new Shrink Compensation a name, enter the new values, click SET.4.

Now the printer is defaulted to the new set of shrink compensation values. The bottom right corner information window is providing the new maximum5.

printable size for XYZ accordingly per shrink compensation. You can now load jobs and print to the printer using these Shrink Compensation values.

Main Page

Important Safety Information5
Safety Symbols and Definitions5
Safety Guidelines5
Protective Equipment/First Aid6
Skin Contact6
Eye Contact6
Contact Lenses6
Packaging Inspection7
Storing a Partially Used Material Cartridge7
Recertiﬁcation Date7
Disposal8
Projet Mjp 2500 Printer Series Features9
Projet 2500 Features10
Projet Mjp 2500 Plus Features11
At a Glance12
Projet 2500 Printer System12
Printing AREA13
3D Printer System Components13
Material Delivery Module (MDM)13
Waste Bag Receptacle13
Additional Documentation13
Electronic Documentation13
User Interface15
Status Tab15
Prints Tab15
Materials Tab16
Settings Screen18
Printer Setup20
Power on Printer21
Changing Waste Bag22
Material Cartridge Removal and Installation24
Removing Material Cartridge24
Installing New Material Cartridge25
Print Platform Removal and Installation28
Personal Hygiene28
Steps for Printing Your First Print30
Check/Add Material in MDM30
Before Starting Print30
Launching Software31
Printing a Part32
Selecting the Printer32
Selecting Material33
Selecting Print Mode33
Selecting Build Style33
Printing the File34
Send Job to Print36
Removing Part36
Printer Shutdown37
Storing Printer for Extended Time Frame37
Mco - Material Changeover Procedure39
Operator Maintenance45
Replacing the Particulate Carbon Filter45
Replacing the Filter Screen46
Inspecting and Cleaning Planarizer Ducts49
Inspect Planarizer Blade51
Clean Print Carriage Optical Home Sensor53
Removing Pixie Dust from Uv Assemblies (Left and Right)55
Confirm Jets59
Jet Check Routine59
Jet Check Evaluation Criteria61
Cleaning Exterior Surfaces65
Cleaning Polycarbonate Top Door66
Cleaning Print Platform67
Cleaning the User Interface68
MDM Maintainance69
Cleaning the MDM Drawer69
Routine Maintenance70
Troubleshooting71
Determine the Scaling Factor to Use for the Next Build72
Shrink Compensation for Projet Visijet® Materials72
Printer Status and Fault Code Recovery80
Non-Fault Code Recovery82
Customer Support Hotline88
Legal Notices89
Copyright and Corporate Identity89
FCC Notice89
Radio Frequency Transmission89
Basic Regulations90
Ec Declaration of Conformity90

3D Systems projet mjp 2500 - Page 74

Table of Contents

Related product manuals