One To One > Ethernet Ports
The Ethernet Ports configures the inbound NAT translation rules (public to private interface translation
direction) for the selected public interface which in this case is the Ethernet port. NAT will perform the IP
address translation on the inbound direction whenever there is a matching rule in the public IP address and
protocol fields translating it to the private IP address. Outbound NAT translation function (private to public
interface translation direction) will perform the IP address translation whenever there is a matching rule in
the private IP address and protocol fields translating it to the public IP address.
Public Destination IP Address Start
The start of the public destination IP address range.
Public Destination IP Address End
The end of the public destination IP address range.
Protocol
The matching protocol where NAT should perform the IP address translation function. Supports ICMP, TCP,
UDP or Any (Any means one among the list; ICMP, TCP, UDP).
Private Destination IP Address Start
This is the start of the Private Destination IP address range. The end of the private destination IP address is
automatically calculated from the start and end of public destination IP address range.
Active
If checked the rule becomes active, if unchecked the rule is inactive.
To Next Page
Loading...
