Software
The Software menu contains the setup and management of the system software including network software
distribution and activation. The distribution of the system software to the remote radios is encrypted by
the AES session key over-the-air.
Single Radio Software Upgrade
The radio software can be upgraded on a single Aprisa SR+ radio (see ‘Single Radio Software Upgrade’ on
page 445). This process would only be used if the radio was a replacement or a new station in an existing
network.
Network Software Upgrade
The radio software can be upgraded on an entire Aprisa SR+ radio network remotely over the radio link (see
‘Network Software Upgrade’ on page 441). This process involves following steps:
1. Transfer the new software to base station with ‘Software > File Transfer’
2. Distribute the new software to all remote radios with ‘Software > Remote Distribution’
3. Activate of the new software on remote radios with ‘Software > Remote Activation’.
4. Finally, activate the new software on the base station radio with ‘Software > Manager’. Note: activating
the software will reboot the radio.
To Next Page
Loading...
