Single Radio Software Upgrade
This upgrade process is for upgrading the software on a single Aprisa SR+ radio.
Note: If a radio has been configured for a Protection Type of ‘Redundant’, and that radio is no longer part
of a Protected Station, the Protection Type must be changed to ‘None’ before the radio software upgrade
can be achieved.
File Transfer Method
The Software Pack is loaded into the radio with the file transfer process (see ‘Software > File Transfer’ on
page 293) and activated (see ‘Software > Manager’ on page 297).
The Aprisa SR+ upgrade operation is indicated by a flashing orange AUX LED.
To upgrade the Aprisa SR+ radio software:
1. Unzip the software release files in to the root directory of a USB flash drive.
2. Insert the USB flash drive into the host port .
3. Using File Transfer, load the software pack into the radio (see ‘Software > File Transfer’ on page 293).
4. Remove the USB flash drive from the host port .
5. Activate the software on the radio (see ‘Software > Manager’ on page 297).
To Next Page
Loading...
