Protected Station Software Upgrade
This upgrade process is for upgrading the software on a single Aprisa SR+ Protected Station.
USB Boot Upgrade Method
Assuming the Primary radio is active and the Secondary radio is standby
1. Using the Hardware Manual Lock switch, force the primary radio to active.
2. Insert the USB flash drive with the new software release into the secondary radio host port .
3. Power cycle the secondary radio. The radio will be upgraded with the new software.
4. When the secondary radio upgrade is completed, remove the USB flash drive, power cycle the secondary
radio and wait for it to become standby.
5. Using the Hardware Manual Lock switch, force the secondary radio to active.
6. Insert the USB flash drive with the new software release into the primary radio host port .
7. Power cycle the primary radio. The radio will be upgraded with the new software.
8. When the primary radio upgrade is completed, remove the USB flash drive, power cycle the primary
radio and wait for it to become standby.
9. When the upgrade process is complete, set the Hardware Manual Lock switch to the Auto position. The
secondary radio will remain active and the primary radio will remain standby. To set the primary radio
to active, use the hardware lock switch to select the primary radio and wait for it to become active,
then set the hardware manual lock switch to the Auto position.
To Next Page
Loading...
