This is done by mapping the external radio network DSCP priority to the internal radio CoS / priority levels
using the ‘DSCP priority definition’ tab. The radio support four queues, thus at maximum a 64 -> 4 CoS /
priority mapping is done.
Default mapping of ingress packet DSCP priority to radio CoS shown in the ‘DSCP priority definition’ tab.
The radio maps all 64 DSCP values. The user can configure most common used 21 DSCP codes and the rest
are mapped by default to low CoS / priority.
Default Priority
When the priority of an Ethernet port uses the DSCP priority (in IPv4 TOS field) values the ‘Default Priority’
option is enabled, allowing the priority of ARP frames to be set to Very High, High, Medium or Low priority.
To Next Page
Loading...
